WaterQuick Tank Recirc pump for
Any Residential Tank Water Heaters

Faucet • Activated • Smart • Technology™

• Faster Hot Water – less than a cup of water is wasted
• Faucet Activated – no buttons or remotes
• Installs at the water heater – not under a sink
• Easy install – DIY or Pro installation
• 3-year warranty
• Customer service – friendly and knowledgable

Recirc Pump Description

WaterQuick – Standard hot water circulation system

Hot water circulation system is the first “true on-demand” hot water circulating system for existing and new homes that delivers hot water when a hot water faucet is turned on.

No wasting water down the drain saving:

• Water
• Sewer
• Energy

A small, high speed, ultra-quiet hot water circulation pump is installed on the hot water outlet of a tank or tankless water heater.

A Bridge Valve connects the hot and cold water supply lines under the most remote kitchen or bath fixture in the house.

When the integrated Flow Manager detects hot water use anywhere in the house, it turns on the hot water pump.

The cool water that normally would go down the drain is circulated back to the water heater through the cold water line.

The Bridge Valve has a built-in temperature sensor that closes when hot water reaches the farthest sink.

Unless a hot water faucet is on the Water Monitor will turn off the pump because hot water is everywhere you need it!

On-Demand Advantages

On-Demand Operation
A demand from any hot water faucet or appliance in the house will start the pump.

• No buttons
• No remotes
• No motion sensors
• No timers

All Water Heaters
The system can be installed on top of a tank style water heater or in-line with a tankless water heater.

• No pumps under cabinets
• No new electrical outlets

Whole House Solution
One pump with one or more Advanced Bridge Valves handles the entire home.

• Lower costs for homes with multiple dead-end plumbing lines

Virtually Maintenance Free
Constructed of high quality stainless steel and low-lead brass ensures years of maintenance free operation.

• Virtually eliminates call backs
• 3 year manufacturer’s warranty

New or Retrofit Installation
3 speed pump means 1 size fits all homes with plumbing lines up to 200′ or more.

• No extra water lines in new homes
• Uses existing water lines in older homes

WaterQuick Standard

Step 1. Choose the appropriate place to install the pump and Flow Monitor:

WaterQuick Standard can be installed in several different configurations. The circulation pump and Flow Monitor can be mounted in either the cold-water supply line to the water heater (right side) or in the hot water supply line going out of the water heater into the house (left side).

Note: It is important that you take into consideration how the pump will be supported and where there is access to an electrical outlet.

WaterQuick Standard: – Hot Water Where You Want It, When You Want it!

WaterQuick Tankless Spec Sheet

1 Dead-End Line

1 – Dead-end plumbing line
1 – Advanced Bridge Valve (comes with kit)

2 Dead-End Lines

2 – Dead-end plumbing lines
2 – Advanced Bridge Valves (1 – comes with kit)

1 – Dedicated Return Line

Tank water heater with:
1 – Dedicated return line

2 – Dedicated Return Lines

Tank water heater with:
2 – Dedicated return lines